![](/images/new-backgrounds/1228635/2286357x1.webp)
DRYER DISPOSAL
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Location Requirements
Tools needed:
■200 mm (8") or 250 mm (10") Pipe wrench
■200 mm (8") or 250 mm (10") Adjustable wrench
■
■Phillips screwdriver
■Adjustable wrench that opens to 25 mm (1") or
■Level
■8 mm (5/16") socket wrench
■Utility knife
■Vent clamps
■
■Caulk gun and caulk (for installing new exhaust vent)
■Pliers
■Putty knife
If installing a gas dryer:
Parts supplied:
Remove parts bag from dryer drum. Check that all parts were included.
■Foot boot (4)
■Dryer foot (4)
NOTE: The circuit diagram for this machine is located inside the lower front panel.
IMPORTANT: Observe all governing codes and ordinances.
■Check code requirements: Some codes limit or do not permit installation of clothes dryers in garages, closets, or sleeping quarters. Contact your local building inspector.
■Make sure that lower edges of the cabinet, plus the back and bottom sides of the dryer, are free of obstructions to permit adequate clearance of air openings for combustion air. See “Recessed Area and Closet Installation Instructions” below for minimum spacing requirements.
NOTE: The dryer must not be installed in an area where it will be exposed to water and/or weather.
4