Installation
Installing | Handles for | Removing | Handles for | ||
Stainless | Steel |
| Stainless | Steel |
|
1.Loosen lower door clip on door with '/4"hex nut driver.
1.Remove plastic button plug at
base of handle with a very small
•Insert '/4"hex nut driver into
predrilled hole to remove screw.
2.Locate predrilled hole at base of handle, and fit hollow end of handle over lower door clip.
3.Fit other end of handle over upper door clip and slide up as far as possible.
NOTE: If top of handle does not
fit over top clip, loosen lower clip further until fit can be
accomplished.
4.Insert '/_"hex nut driver into predrilled hole at base of handle to tighten screw. Insert screw plug into hole, as illustrated.
5.Repeat above steps to install other handle.
2.Slide handle down and remove from bottom door clip.
3.Repeat above steps to remove other handle.
