Maytag Refrigerator warranty Wide-by-Side TM Handles, Full-Length Aluminum Handles, To Remove

Installation

Wide-by-Side TM Handles

To Install:

1.Align fresh food handle with trim retainer and door clip.

2.Make sure the tabs of the handle clip are below the tabs of the door clip.

3.Rotate the handle so that the handle is flat against the door (see page 6).

/4. The tab on the lower part of the handle will align with the hole in the handle cap.

5.Slide handle upward until it clicks.

6.Snap top of handle into trim retainer clip.

7.Repeat for freezer handle.

To Remove:

Protect the area above the handle

trim with tape. Insert the tip of a flat blade screwdriver between the handle trim and door

panel. Carefully pry the trim away from the door panel.

. Pull trim free from the trim retainer.

3.Insert door removal card (or '/_2"thick plastic card)) between the handle and door panel (approximately 1'/2").

. Grasp the handle firmly and pull downward to rem ove.

5. Repeat for freezer handle.

Full-Length Aluminum Handles

To Install:

1.Release top door trim by removing Phillips screws from top of fresh food door and retain screws for later use.

Align notches on back of handle with retaining clips on doors. Insert clips into notches and slide handle

down until it contacts bottom trim.

Replace	top door trim and	Door Clip
Phillips	screws.

Repeat instructions 1-3 to install other handle.

To Remove:

1.Release top door trim by removing Phillips screws from top of fresh food door and retain screws for later use.

Grasp handle firmly with both hands. Slide handle upward

approximately _4"to release.

. Repeat instructions 1-2 to remove other handle.

To Reinstall:

1. Repeat in reverse order.