Disassembly Procedures
To avoid the risk of electrical shock, personal injury or
! WARNING death; disconnect power to oven and shut off gas supply before following any disassembly procedure.
Removing and Replacing Unit | Surface Burner Micro Switch(es) |
1. Turn off gas and power supply to the oven.
NOTE: To avoid property damage, place a protective covering on the floor.
2.Slide unit forward, out of the installation position.
3.Disconnect or unplug the power cord leading from unit to junction box or outlet depending on connection.
4.Turn off gas supply and disconnect from main gas line.
5.Reinstall oven, using Installation Instructions.
1.Turn off gas and power supply to the oven.
2.Release control panel cover, see "Control Panel" procedure, steps 1 through 5.
3.Disconnect and label wire terminals from micro switch located on the burner valve.
4.Remove micro switch from burner valve, by pulling switch from burner valve.
5.Replace component and reverse procedure to reassemble.
Surface Burner Valve(s)
Knob Bezel(s)
1.Turn off gas and power supply to the oven.
2.Remove surface burner knobs from control panel, by pulling knobs straight off.
3.Remove oven control knobs from control panel.
•Rotating knob to gain access to set screw.
•Loosen set screw on knob.
•Rotate knob to "OFF" position and remove.
4.Remove screws securing knob bezel to control panel.
5.Replace component and reverse procedures to reassemble.
Control Panel, Rocker Switch(es), and Indicator Light(s)
1.Release control panel cover, see "Control Panel" procedure, steps 1 through 5.
2.Remove micro switch from burner valve.
3.Disconnect gas line from surface valve.
4.Unscrew burner valve from manifold pipe.
NOTE: Some additional components maybe required to be disconnected or removed. This will allow access for valve to be unscrewed from manifold pipe.
5.Replace component and reverse procedure to reassemble.
NOTE: When installing valve, use pipe dope compound. Perform gas leak test to ensure unit will not leak and unit operates properly.
1.Turn off gas and power supply to the oven.
2.Remove surface burner knobs from control panel, by pulling knobs straight off.
3.Remove oven control knobs from control panel.
•Rotating knob to gain access to set screw.
•Loosen set screw on knob.
•Rotate knob to "OFF" position and remove.
4.Remove screws securing control panel cover to chassis.
5.Roll top portion of control panel cover downward to gain access to components.
6.Disconnect and label wire terminals from rocker switches.
7.Slide indicator lights to the side to release from holders.
NOTE: Once an indicator light is released from the holder the front lens will fall out.
Oven and Surface Broiler Infinite Switch
1.Turn off gas and power supply to the oven.
2.Release control panel cover, see "Control Panel" procedure, steps 1 through 5.
3.Disconnect clips securing sensor bulb.
4.Remove screws securing switch to mounting bracket.
5.Disconnect and label wire terminals from switch.
6.Slowly guide sensor bulb from unit.
7.Replace component and reverse procedures to reassemble.
NOTE: Perform gas leak test to ensure unit will not leak and unit operates properly.
©2004 Maytag Services | 16023219 | 15 |
