Disassembly Procedures
!WARNING
To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and shut off gas supply before following any disassembly procedure.
Front Facade
This piece is spot welded into place, so it is not replacible.
Module Type
Surface Burner
1.Turn off gas and power supply to the oven.
2.Remove grates and burner caps from module.
3.Remove screw securing burner assembly to the mounting bracket.
4.Remove screw securing ignitor to burner mounting bracket.
5.Disconnect wire terminal from ignitor.
6Replace component and reverse procedure to reassemble.
Charboil
1.Turn off gas and power supply to the oven.
2.Remove grates from module.
3.Release control panel cover, see "Control Panel" procedure, steps 1 through 5.
4.Disconnect gas lines from surface valve.
5.Disconnect and label wire terminals from gas valve.
6.Remove screws securing gas module to mounting bracket.
7.Remove screws securing ignitor to module.
8.Remove nuts securing burner mounting bracket to module.
9.Remove burner from module.
10.Replace component and reverse procedure to reassemble.
Griddle
1.Turn off gas and power supply to the oven.
2.Remove griddle from module.
3.Remove screws securing ignitor to module.
4.Remove screw securing burner to module.
5.Remove burner from module.
6.Replace component and reverse procedure to reassemble.
©2004 Maytag Services | 16023219 | 19 |
