Installation
3. Locate handle trim in literature pack and install over top and bottom of handle, as illustrated.
•Secure top handle trim with remaining screw removed in step 1.
•Snap bottom trim over bottom portion
of handle.
To Remove:
1. Remove top handle trim by removing top handle screw.
• Retain trim and screw for later replacement.
2. Pry bottom handle trim from handle with screwdriver flat blade wrapped in masking tape.
•Retain trim for later replacement.
3.Remove two hex head screws.
•Retain screws for later replacement.
Side Mount Handle
Materials Needed
• Phillips screwdriver
To Install:
1.Remove screws from the side of the door.
2.Align the side mount handle with the predrilled holes in the door panel.
3.Insert the screws in the sequence as shown.
Upper | 2 | |
Handle | ||
| ||
1 | 4 | |
Lower | ||
3 | ||
Handle | ||
|
4.Ensure the door handle is snug to the door panel.
To Remove:
Reverse installation procedure.
Freezer Handles
Materials Needed
• Phillips screwdriver
To Install:
1. Install handle by fastening with screws removed from edge of door.
• If reversing freezer door, remove door plugs from top edge of door and insert into screw holes.
To Remove:
1. Remove handle screws with Phillips screwdriver and retain screws for later use.
Front Mount Handle - style 2
Materials Needed
•Gloves to protect hands
•Phillips screwdriver
•Plastic door removal card (or 0.1 cm thick plastic card), retain the card
Attach Extensions to
Handle: (select models)
1. Align handle and extension as shown.
2.Place extension in handle opening.
3.Apply slight pressure to both sides of the extension piece.
4.Slide extension until it stops on inside edge of handle.
To Install:
1. The handles are to be oriented as shown.
2. Align front mount door handle
clip with the door tabs. |
| |
3. Ensure the handle clips are | Handle | |
positioned slightly above the | ||
Clip | ||
door tabs. | ||
| ||
| Door | |
| Tab |
5