IMPORTANT TO OWNER
Retain these instructions for future reference.
This new Maytag appliance is designed to serve you dependably for many years. However, it cannot do so unless provided with sufficient electrical power, suitable exhausting and if a gas model, adequate gas supply. We urge you to read this carefully to make sure all requirements are met.
Operating instructions, safety precautions and your warranty are in the accessory package with each appliance. Read the operating instructions carefully.
NOTE: A wiring diagram for the dryer is located on the inside of the dryer access panel. A wiring diagram for the washer is located on the inside of the washer cabinet.
UNCRATING
To remove carton, cut around bottom of carton on or below dotted line. Cut down each corner of carton (vertically) and “peel” carton away from stacked washer/dryer. Fold carton material for removal. Check the unit for shipping damage.
Remove the tape between the washer cabinet and the dryer stand. Disconnect the control wire harness which leads from the dryer to the washer. You will need to depress the locking tabs to separate the connector.
From the back of the stacked washer/dryer, grasp the dryer and stand. Pull dryer and stand back and off of washer and shipping base. As dryer and stand are pulled back, carefully drop dryer stand rear legs to
the floor before clearing shipping base. (Do not drop dryer and stand off of shipping base!)
Untape and open washer lid. Remove installa- tion accessory package, fill hoses and close lid. Leave tub block in place until installation is complete. Be sure to remove tub block after installation is complete and before use!
Using the carton corner posts stacked in pairs, lay the washer on the posts on the left side. Remove the crate base wires from the carton base. Use pliers or screwdriver to pry wires from wood. (Do not kick the shipping base off the washer.)
Run washer rear legs all the way up into the rear corner brackets. Lock in place by tightening lock nuts up against base. Leave front legs loose for leveling later.
Install the vinyl feet on the washer legs.
Lay a piece of the shipping cardboard along the bottom edge of the cabinet and stand the washer back up. (The cardboard protects the lower edge at the cabinet and the floor when standing the washer back up.)
NOTE: With the rear washer legs adjusted up, cabinet corner brackets in the rear can touch and damage floor if caution is not used when moving washer.
The dryer and stand are installed first. Necessary electrical, gas (if gas stacked washer/ dryer) and vent connections are made as dryer and stand are put in position and leveled. Let’s first look at what facilities are needed.
printed in U.S.A. | 1 |
