Maytag W10096984A Installation Requirements, Tools and Parts, Tools needed for all installations

In the State of Massachusetts, the following installation instructions apply:

�Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts.

�If using a ball valve, it shall be a T-handle type.

�A flexible gas connector, when used, must not exceed 3 feet.

IMPORTANT SAFETY INSTRUCTIONS

When discarding or storing your old clothes dryer, remove the door.

SAVE THESE INSTRUCTIONS

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.

Tools needed for all installations:

Adjustable wrench that opens to 1" (25 mm) or hex-head socket wrench

Flat-blade screwdriver #2 Phillips screwdriver

Utility knife

Caulking gun and compound (for installing new exhaust vent)

1/4" nut driver or socket wrench (recommended)

Tape measure

Tools needed for gas installations:

Tin snips (new vent installations)

8" or 10" pipe wrench	8" or 10" adjustable wrench
	(for gas connections)

Vent clamps

LevelPliers

Pipe-joint compound resistant to LP gas

4