Maytag W10199707A 4, 2, 3, 1, 1

17
Place paper towel under 90°elbow fitting. Turn on water
supply and check for leaks. If leak occurs, repeat
previous step.
If needed, see website for animated representation
of this step. Visit www.maytag.com/drain under
FAQ tab.
4Check for leaks
2Slide clamp onto connector
Drain hose
Green clamp
Black drain hose
connector
Stop
Stop
Drain hose stop
Using pliers, squeeze open the small green drain hose
clamp and slide onto connector between stops.
3Hose clamp final position
Drain hose
Green clamp
Black drain hose
connector
Stop
Stop
Drain hose stop
After hose is connected, remove towel.
If needed, see website for animated representation of
this step. Visit www.maytag.com/drainunder FAQ tab.
Connect to Drain
Place towel under drain hose to catch any water in drain
hose. Place the small green drain hose clamp onto the
small end of the drain hose. Push the new drain hose
into the black drain hose connector up to the drain hose
stop.
1Connect drain hose
Drain hose
Green clamp
Black drain hose
connector
Stop
Stop
Drain hose stop
Make Direct Wire Electrical
Connection
Route cable so that it does not touch dishwasher motor
or lower part of dishwasher tub. Pull cable through cable
clamp in terminal box.
Select UL listed or CSA approved twist-on wire connectors
(not included) rated to connect your household wiring to
16-gauge dishwasher wiring.
1Direct Wire-—Route cable
into terminal box
Option B, Direct Wire:
NOTE: If the power supply cord was connected earlier
proceed to “Secure Dishwasher in Cabinet Opening”
section.