Verify Anti-Tip Bracket Location
1.On models with a storage drawer, remove storage drawer. See the “Storage Drawer” section.
On models with a warming drawer, the rear leg cannot be seen by removing the warming drawer. It will be necessary to view the rear foot from outside the range.
2.To check that the
■Look for the
■Slide range back so rear range foot is under
Level Range
1.Place rack in oven.
2.Place level on rack and check levelness of range, first side to side; then front to back.
3.If range is not level, pull range forward until rear leveling leg is removed from the
On Ranges Equipped with Storage Drawers:
Use a ¼" drive ratchet, wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in
On Ranges Equipped with Warming Drawers:
Use a wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in
NOTE: Range must be level for satisfactory baking performance.
4.Replace the storage drawer (on some models).
Storage Drawer
The storage drawer can be removed. Before removing, check that the storage drawer is cool and empty. A
To Remove:
1.Pull the storage drawer forward to the drawer stop. Push the drawer back approximately 1" (2.5 cm).
It will be necessary to disengage the storage drawer one side at a time.
2.Insert a
A
A. Drawer clip
3.Depress the drawer clip by pressing the screwdriver handle toward the side of the storage drawer.
A
A. Drawer clip - view from outside of storage drawer
4.Gently pull forward on the storage drawer until the depressed clip clears the drawer glide.
5.Repeat steps 2, 3, and 4, for the other side of the storage drawer.
6.Lift up the back of the storage drawer and remove.
12
