3.Feed the power supply cord through the strain relief on the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block.
A 
B
C
D
A. Terminal block
B.
C.UL listed strain relief
D.Power supply cord wires
4.Use a Phillips screwdriver to connect the green ground wire from the power supply cord to the range with the
5.Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the
3-wire connection: Power Supply Cord
Use this method only if local codes permit connecting chassis ground conductor to neutral wire of power supply cord.
1.Feed the power supply cord through the strain relief on the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block.
A 
B
C
D
A. Terminal block
B.
C.UL listed strain relief
D.Power supply cord wires - large opening
2.Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the
A | F |
| |
B |
|
C | E |
| |
| D |
A. | D. Green ground wire |
B. | E. Neutral (center) wire |
C. Line 2 (red) | F. Line 1 (black) |
6.Connect line 2 (red) and line 1 (black) wires to the outer terminal block posts with
7.Securely tighten hex nuts.
NOTE: For power supply cord replacement, use only a power cord rated at 250 volts minimum, 40 amps or 50 amps that is marked for use with nominal 1³⁄₈" (3.5 cm) diameter connection opening, with ring terminals and marked for use with ranges.
8.Tighten strain relief screws.
9.Replace terminal block access cover.
A | E |
|
B | D |
| |
C |
|
A. | D. Neutral (white) wire |
B. Line 2 (red) | E. Line 1 (black) |
C.
3.Connect line 2 (red) and line 1 (black) wires to the outer terminal block posts with
4.Securely tighten hex nuts.
NOTE: For power supply cord replacement, use only a power cord rated at 250 volts minimum, 40 amps or 50 amps that is marked for use with nominal 1³⁄₈" (3.5 cm) diameter connection opening, with ring terminals and marked for use with ranges.
5.Tighten strain relief screws.
6.Replace terminal block access cover.
9
