Maytag W10578036B - SP, W10577942B manual Vibration or Off-Balance, Noises, Water Leaks

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.amana.com/help

for assistance and to possibly avoid a service call.

If you experience

Possible Causes

Solution

Vibration or Off-Balance

Vibration, rocking, or “walking”

Feet may not be in contact with the	Front and rear feet must be in firm contact with floor, and washer
floor and locked.	must be level to operate properly. Jam nuts must be tight
	against the bottom of the cabinet.
Washer may not be level.	Check floor for flexing or sagging. If flooring is uneven, a 3/4"
	(19 mm) piece of plywood under your washer will reduce sound.
	See “Level the Washer” in Installation Instructions.
Load could be unbalanced	Avoid tightly packing the load. Avoid washing single items.
or too large.	Balance a single item such as a rug or jeans jacket with a
	few extra items.
	Item or load not suitable for selected cycle. See “Cycle Guide”
	and “Using Your Washer.”
The shipping bolts are still in the	See “Remove transport bolts from washer” in the
back of the washer.	Installation Instructions.

Noises

Clicking or metallic	Door locking or unlocking.	The door will lock unlock and lock again. You will hear 3 clicks
noises		after touching and holding HOLD TO START. This is normal.
	Objects caught in washer	Empty pockets before washing. Loose items such as coins
	drain system.	could fall between washer drum and tub or may block pump.
		It may be necessary to call for service to remove items.
		It is normal to hear metal items on clothing such as metal snaps,
		buckles, or zippers touch against the stainless steel drum.
Gurgling or humming	Washer may be draining water.	The pump may make a humming sound with periodic gurgling
		or surging as final amounts of water are removed during the
		spin/drain cycles. This is normal at certain stages of the cycle.
Rolling or sloshing	Steel balls in the balancing system	This is normal at certain stages of the cycle.
and occasional clicking	are balancing the load.
(on slow-speed spin)
Water Leaks
Check the following for	Fill hoses not attached tightly.	Tighten fill-hose connection.
proper installation
	Fill hose washers.	Properly seat all four fill-hose flat washers.
	Drain hose connection.	Check that the drain hose is properly secured to drainpipe or
		laundry tub.
	Check household plumbing for leaks	Water can back up out of a clogged sink or drainpipe. Check
	or clogged sink or drain.	all household plumbing for leaks (laundry tubs, drainpipe, water
		pipes, and faucets).
Water or suds leaking	Not using HE detergent or using too	Only use HE detergent. Suds from regular detergents can
from door or rear of	much HE detergent.	cause leaking from the door or rear of cabinet. Always measure
cabinet		detergent and follow manufacturer’s directions based on your
		load requirements.
	Residue on door glass.	Periodically clean the underside of the glass window to avoid
		potential leaks.
	Door opened during “Add a	Water can drip off the inside of the door when the door is
	Garment.”	opened after the start of a cycle.

Washer Not Performing as Expected

Load not completely covered in water

Water level not visible on door or does not cover clothes.

This is normal for an HE front load washer. The washer senses load sizes and adds the correct amount of water for optimal cleaning.

14