3.Position the lower shoulder strap clamp under the shaft and align the upper and lower clamp screw holes.
Upper shoulder strap clamp
Lower shoulder |
|
strap clamp | Screws |
|
4.Insert two screws into the screw holes.
5.Secure shoulder strap clamp by tighten- ing screws with a hex wrench.
HARNESS
ADJUSTMENT
FOR BALANCE
15 cm |
|
|
|
below |
|
| 10 |
waist |
|
| above |
|
| 76 cm | ground |
|
|
|
|
76 cm
ATTACHING THE SHIELD
WARNING: The shield must be prop- erly installed. The shield provides partial protection to the operator and others from the risk of thrown objects, and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on un- derside of shield) is sharp and can cut you.
1.Insert bracket into slot on shield.
2.Pivot shield to align holes in shield and bracket.
Bracket
Slot Shield
3. Secure shield to bracket with bolt.
Bolt
CONFIGURING YOUR UNIT
You can configure your unit using a cutting head for grass and light weeds, or a weed blade for cutting grass, weeds, and brush up to 1 cm in diameter. To assemble your unit, go to the sec- tion for the desired configuration and follow the instructions.
ASSEMBLY INFORMATION - TRIMMER HEAD
TRIMMER
HEAD
NOTE: Remove the blade before attaching the trimmer head. To remove blade, align hole in the dust cup with the hole in the side of the gearbox by rotating the blade. Insert a small screwdriver into aligned holes. This will keep the shaft from turning while loosening the blade nut. Remove blade nut by turning clockwise. Remove the screwdriver. Remove both washers and blade. See INSTALLATION OF THE METAL BLADE for illustrations. Be sure to store all parts and in- structions for future use. Never use the trimmer head with the metal blade installed.
7
