Using Your
Handheld Steam Cleaner
FILLING BOILER
1.Place Handheld Steam Cleaner on a flat, level surface.
2.Make sure power cord is unplugged from electrical outlet.
3.Cautiously remove Boiler Cap by unscrewing it in a
CAUTION: Refer to Refilling procedure below for additional safety precautions that must be taken when refilling the unit after it has been in use.
4.Boiler should always be emptied after each use. If it was not emptied after the previous use, empty it now – this will make it easier to fill with the correct amount of water.
5.Fill included Measuring Cup with 6 oz. (180 ml.) of water.
NOTE: In order to extend the life of your Handheld Steam Cleaner and keep it functioning at it’s maximum potential, it is highly recommended that distilled or
6.Carefully pour water from Measuring Cup into Boiler through fill hole.
NOTE: Do not exceed the Boiler’s maximum capacity of 6 oz. (180 ml.). This will ensure a better flow of steam with minimal dripping water.
7.Replace Boiler Cap, screwing it in a clockwise direction to tighten. Make sure it is screwed on securely to prevent hot water or steam from escaping.
REFILLING
If unit has been in use, always use the following safety precautions before removing the Boiler cap to add water:
1.Unplug power cord from electrical outlet.
2.Allow
3.Press and hold Steam Button to release any remaining steam pressure. Steam can remain pressurized inside Boiler for up to one hour after use.
4.Slowly remove Boiler Cap and add water as outlined in Steps
CAUTION: Boiler may contain some amount of water that is still hot – use care when refilling to avoid burns or other injury.
WARNING: Extreme caution should be used when pouring water into a Boiler that was recently heated – cool water introduced into a warm Boiler may result in a small burst of steam and water. Do not look directly down into fill hole when filling. Keep your free hand and any children or pets at a safe distance.
ENGLISH 9
