McIntosh C45 owner manual How to Operate by Remote Control

How to Operate by Remote Control

How to Operate by Remote Control

	stored in the tuner memory. Press +10 Push-button a second
The supplied Remote Control is capable of directly control-
	time to stop on a station preset and exit the review process.
ling the functions of contemporary McIntosh Source Com-
	Press the NEXT or BACK Push-buttons to step
ponents connected to the C45. Earlier McIntosh source
	through the Preset Radio Stations when the optional TM1
components and other brand source components can be con-
	AM/FM Tuner Module is installed into the C45.
trolled by the C45 Remote Control with the addition of a
McIntosh Remote Control Translator (RCT).	Volume
Note: Your McIntosh Dealer can assist you with the
	Press the UpS or DownT VOLUME Push-button to raise
installation and operation of the Remote Control
	or lower the listening volume level.
Translator (RCT).
Mute	Note: The TAPE and VCR OUPUTS are not affected by
Press the MUTE Push-button to mute audio at the Audio		volume changes.
Control Center Outputs, except the TAPE and VCR OUT-	Acc On
PUTS. Press MUTE a second time to unmute audio.
	Press ACC ON to turn the power ON to a McIntosh Disc
Mode	Player.The ACC ON/OFF Push-buttons also control the sig-
	nal at the ACCessory(B) Power Control Jack, unless it is
Press the MODE Push-button to select between 2 Channel
	reassigned to a specific Input(s) from the default setting.
and 6 Channel operation.
	For additional information refer to page 19 “Power Control
Trim and Level	Triggers” in this manual.
	Note: When the C45 is switched Off (Standby Mode) the
Press the TRIM Push-button, followed by the LEVEL UpS
		ACCessory(B) Power Control Signal will be reset to the
and DownT Push-buttons to select various fuctions and
		default turn-on setting of Off.
make sound adjustments. For additional information refer to
pages 21 thru 23.	Acc Off
Input Source Selection	Press ACC OFF to turn the power OFF to a McIntosh Disc
	Player.
Press one of the Input Push-buttons to select either a default
or reassigned program source.	Pause
Disc/Tape Functions	Press	to perform various functions on a variety of McIn-
	tosh Components. It will also pause the playing of a Disc or
Use these push-buttons to operate a Disc Player or Tape Re-
	Tape playback.
corder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre-
sets or Disc chapters/tracks/discs.
Disc and Track
Use the DISC and TRACK Push-buttons when a Disc Play-
ers is being used.
Note: Certain Disc Players will require a Numbered Push-
button be pressed immediately after the Disc or Track
Push-button is depressed.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel UpS or
DownT Push-button to move from station to station. Press
and hold a Channel UpS or DownT Push-button to move
continuously from station to station. Press +10 Push-button
to start the automatic brief audition of each of the presets

25