McIntosh C45 owner manual How to Operate the Setup Mode, Default Settings, Setup Function Name

Setup

How to Operate the Setup Mode

Your McIntosh C45 has been factory configured for default operating settings that will allow immediate enjoyment of superb audio without the need for further adjustments. If you wish to make changes to the factory default settings, a Setup Feature is provided to customize the operating set- tings using the Front Panel Alphanumeric Display.

1.Press the POWER Switch to ON, the Red LED above the STANDBY/ON Push-button lights to indicate the C45 is in Standby mode. To switch On the C45 press the STANDBY/ON Push-button. Refer to figure 3.

2.Press the C45 Front Panel SETUP Push-button. The LED above the SETUP Push-button will illuminate and the Front Panel Display will indicate DISPLAY 10. Re- fer to figure 1.

Figure 1

Note: The Front Panel Display will indicate DISPLAY 10 the first time, after that it will display whatever Setup Mode was last accessed.

3.Press TONE BYPASS (Menu) Push-button and notice that with each press of the push-button, the Setup Mode advances through ten different possible adjustment se- lections and one informational display.

Note: If the optional TM1 AM/FM Tuner Module is installed into the C45 there will be 2 additional adjustments relating to the TM1.

Figure 2

4.To exit from a specific Setup Mode, press the SETUP Push-button a second time. The LED above the SETUP Push-button will extinguish and the Front Panel Display will revert back to its normal display. Refer to figure 2.

Default Settings

The following listings indicate the default settings without the optional TM1 AM/FM Tuner Module installed and the page number for instructions on how to change a setting:

Setup Function Name	Setting	Page Number
Display (Brightness)	10	16
Version (C45 Firmware)	C45 _ . _ _	16
Input 2	*TUN	17
Level (Input Trim)	0.0	17
6 Channel 1 (Input)	Off	18
6 Channel 2 (Input)	Off	18
Balanced (Input)	Off	18
2Ch Sub	Off	19
Trig Tun	--	19
AutoTone	Off	19
Remote (Control Type)	Norm	20

The following listings indicate the default settings with the optional TM1 AM/FM Tuner Module installed and the page number for instructions on how to change a setting:

Setup Function Name	Setting	Page Number
Display (Brightness)	10	16
Version (C45 Firmware)	C45 _ . _ _	16
Country Code	_ _ _ _ _ _	16
Tune - >	Tune	16
Input 0	*TUN	17
Level (Input Trim)	0.0	17
6 Channel 1 (Input)	Off	18
6 Channel 2 (Input)	Off	18
Balanced (Input)	Off	18
2Ch Sub	Off	19
Trig Tun	--	19
AutoTone	Off	19
Remote (Control Type)	Norm	20

Figure 3

15