The unit is designed to measure pressure changes at your specific location, when LOCAL barometric pressure is selected. Information for programming your unit, with either Altitude or Sea Level values, may be obtained from GPS readings, online from the Internet, etc.

SEA LEVEL barometric pressure provides you with information about pressure changes at lower elevations in your surrounding area. The SEA LEVEL pressure value can be set to match your local metro area weather information. (Sources – local TV or radio station, etc.)

SETTING INITIAL PRESSURE PARAMETERS IMPORTANT: Allow the unit to set without touching ANY buttons for about 6-8 minutes during the main unit initial set up. This will give the unit time to synchronize with remotes, stabilize pressure readings and settle with default settings.

SELECT PRESSURE UNITS OF MEASURE

Press UP (? ) or DOWN (? ),as needed, until the pressure icon “PRESSURE”, to the left of the barometric pressure value, begins to flash.

Press MODE button, to toggle through selections until “SEA LEVEL” or “LOCAL” barometric pressure is displayed.

Press and hold MEM/ HISTORY button to enter the pressure unit selection mode. Press the UP (? ) or DOWN (? ) button to select the preferred units of measure for pressure: inHG (English), hPa/mBar (scientific) or mmHg (metric)

Press MEM/ HISTORY to confirm your selection. Then press MODE to move to the ALTITUDE unit selection mode. Press the UP (? ) or DOWN (? ) button to select pressure unit as FEET or METER.

Press MEM/ HISTORY to confirm and hold MODE to move to the ALTITUDE value selection mode.

Press UP (? ) or DOWN (? ) to select or adjust the altitude value to your location. (Press and hold either button for accelerated digit advance)

Press MODE to confirm the programming selection.

(NOTE: The unit will automatically exit programming mode if it does not detect a button press after 2 minutes.)

11

Page 11
Image 11
Meade TE688W user manual Select Pressure Units of Measure