COPYRIGHT © 2003 MERIT INDUSTRIES, INC.
Site Preparation
In determining the location for your Megatouch FORCE™ video game, consid- eration must be given to a suitable, grounded electrical outlet. Since the game is a com- puterized device, it should have a separate circuit, if at all possible. If a separate circuit is not available, care should be taken to pro- vide a clean and constant voltage. As a basic guideline, never connect the unit to a circuit that also supplies power to freezers, coolers or other high power consuming and electrical noise generating equipment. Place the game in a location where nothing will interfere with proper ventilation. The game should not be exposed to any dripping or splashing liquids. Objects filled with liquid should not be placed on the unit.
The upright model should be located on a sturdy, level surface. The game will only remain stable when the leg levellers are ex- tended and level. Extend the leg levellers until they contact the floor and remove the weight of the game from the cabinet wheels. There are also two stabilizer rods in the back of the game to provide stability if the game is not placed against a wall (see Figure 25). Extend the threaded rods until they contact the floor. When the game is properly ad- justed, it should remain stable.
Setting up your Megatouch Game
1.After removing the game from the car- ton, attach the power cord to the back of the game, near the on/off switch. Plug the game into a standard AC out- let.
2.Turn the power switch at the back of the game to ON and wait for it to go through its
3.The machine has been preset at the factory and therefore should not need
to be adjusted, however it is recom- mended that the screen be calibrated (see “Screen Calibration”) and the coin or bill acceptor(s) be tested.
4.There are many custom settings avail- able for the game. To customize the settings, follow the instructions begin- ning with the Main Menu section in this manual.
Game Description
The Megatouch Fusion™ comes housed in a 17” upright cabinet. This model has 3 key- locked compartments: the main bezel door, the rear door and the coin/bill door. It is equipped with a coin mech and/or bill stacker, and optional bill acceptors are also avail- able. This model also has couplers installed in the rear of the game. These are used for future hardware upgrades which include linking and modem capabilities. Enclosed in some games along with the keys and war- ranty card is an Ethernet cable and a cross- over connector which can be used to link games. For linking information see “Linking Games” in the next section.
Rear Door Compartment
The rear compartment of the Fusion allows access to storage space for
CPU Section
The CPU section is accessible by opening the front bezel. The CPU section houses the monitor, motherboard, I/O board, power supply, hard drive, centronics connector, and the main harness.
Located in the CPU section on the I/O board are two internal switches, SETUP and CALI- BRATE. Pressing the SETUP button will bring you to the Megatouch Setup Screen. See the next section for calibration instructions.
NOTE: Additional “SET UP” and “CALI- BRATE” buttons are located on the con- trol board attached to the front bezel.
1 | MEGATOUCH FUSION UPRIGHT OWNER’S MANUAL |
