Memorex Digital Video Disc Player Check the following before requesting service

Check the following before requesting service:

GENERAL SYMPTOM		POSSIBLE CAUSE	POSSIBLE SOLUTION
No power.		AC cord unplugged.	Plug in the AC cord to an AC outlet.
Power on, but unit not functioning		Condensation has formed.	Unplug the unit and wait about one to
properly.			two hours to allow the player to dry.
		Wrong type of disc inserted.	This unit cannot play discs otherthan
			those listed on page 16.
		Unit needs to be reset.	Press the POWER/STANDBY button,
			then unplug the power cord. Wait one
			minute and then plug the unit back in.
		The disc is dirty or inserted incorrectly.	Clean disc and insert label side-up.
		Some features and functions are not	This is normal; try another function.
		available on all discs.
No picture.		The equipment is not connected properly.	Connect the equipment according to
			the instructions in this manual.
		The INPUT of the TV is not set to receive	Select the appropriate video input
		the disc signal output.	mode, usually VIDEO or AV.
		The video cables are not securely	Connect the video cables securely.
		connected.
		The connected TV power is off.	Turn the TV on.
No sound.		The equipment is not connected properly.	Connect the equipment according to
			the instructions in this manual.
		The equipment connected with the audio	Select the appropriate audio input
		cable is not set to receive the Player	mode.
		signal input.
		The audio cables are not securely	Connect the audio cables securely.
		connected.
		The connected receiver’s power is off.	Turn the audio receiver on.
The playback picture is poor.		The disc is dirty.	Clean the disc.
The Search feature is not working.		Some discs have sections that do not	This is normal on some discs.
		allow searching.
The picture is not fitting properly.		Wrong menu option is selected in the	Select the correct TV type (PS, LB, WIDE)
		Setup menu.	which matches the TVyou are using.
The remote control is not working.		The batteries are weak or dead.	Install fresh batteries.
		The batteries are not installed properly.	Install batteries according to the diagram.
		The remote is not aimed at the sensor.	Aim the remote at the sensor.
		Distance is too far or there is too much	Operate within 20 ft, or reduce the light
		light in the room.	in the room.
		There is an obstacle in the path of the	Move the obstacle.
		beam.
The Preferences menu cannot be		There is a disc in the disc tray.	Remove the disc from the disc tray, as
accessed (it is dimmed) in the			there cannot be any disc inserted when
Setup menu.			setting the preferences.
	39