CONTROL PANEL FEATURES
1.Main Power On/Off Switch – supplies power to the toaster.
2.Power Indicator Light – this red light will illuminate when heating element is energized. Main Power Switch must be in the “ON” position.
3.Conveyor Speed Control – regulates the speed of the conveyor belt. Rotate this control to a higher number to increase the speed of the conveyor belt. Rotate to a lower number to decrease speed of the conveyor belt.
OPERATION INSTRUCTIONS
1.Set Main Power On/Off Switch to the “ON” position. Red Power Indicator Light will illuminate.
2.Set Conveyor Speed Control for desired setting.
3.PRE-HEAT FOR 30 MINUTES.
4.After
ALWAYS PUT CUT SIDE OF BUN FACING THE PLATEN SURFACE.
5.If the product you are toasting is too light, decrease the speed of the conveyor belt. If the product is too dark, increase the speed of the conveyor belt.
CLEANING INSTRUCTIONS
CAUTION: UNPLUG UNIT AND ALLOW PLATEN TO COOL BEFORE CLEANING.
1.Do not use product such as steel wool on any part of the toaster.
2.The
3.Daily cleaning of Platen and coated Platen Sheets: After platen has cooled thoroughly, remove the coated platen sheet. Wipe the sheet with a soft, damp cloth and dry thoroughly. Lay coated platen sheet flat. Do not crinkle. With platen in the upright position, scrub with an abrasive plastic pad (i.e. ScotchBrite) until platen is “sparkly” clean.
4.Daily cleaning of conveyor belt: With the conveyor belt running, use a stiff bristled brush (NOT METAL) and with side to side motion, brush away any crumbs that may be present.
3