Maintenance
The
Head cleaning may be done by using disposable,
The reader exterior surface is covered with high strength polymer and polyester membrane. It may be cleaned with a soft cloth and mild detergent if required.
Specification:
The reader/Interface are for use in low voltage, class 2 circuits only.
Electrical: | Voltage - | 12 Vdc (10.2 to 13.8 Vdc) |
| Current - | 200mA |
| Relay contacts- K1, 5A@30Vdc; K2, 1A@30Vdc | |
| Distance between reader/interface - 500' (152m) max., 22AWG | |
| ||
Mechanical: | Reader: |
|
| Dimension - | 1.95" (50mm)W x 1.30" (33mm)H x 5.50" (140mm)L |
| Weight - | 10 oz. (284 g) nominal |
| Interface: |
|
| Dimension - | 3.25" (83mm)W x 2.9" (74mm)L x 1.4" (36mm)H |
| Weight - | 4 oz. (120 g) nominal |
Environmental: | Temperature: | |
|
| |
| Humidity: | Reader- 100% RHNC; Interface- 95% RHNC |
WARRANTY
Mercury Security Corporation warrants that the product is free from defects in material and workmanship under normal use and service for two years from factory shipment. Mercury Security Corporation assumes no responsibility for products damaged by improper handling or installation. This warranty is limited to the repair or replacement of the defective unit.
There is no expressed warranties other than set forth herein. Mercury Security Corporation does not make, intends, nor does it authorize any agent or representative to make any other warranties, implied warranties, and expressly excludes and disclaims all implied warranties of merchantability of fitness for a particular purpose. Returned units are repaired or replaced from a stock of reconditioned units. Returns must be accompanied by a return authorization number obtained form customer service, a purchase order and prepaid postage.
LIABILITY
The card readers should only be used to control exits from areas where an alternate method for exit is available. This product is not intended for, nor is rated for operation in
Mercury Security Corporation, © 2005 | Doc. | Page 17 |