Specifying information about your system
You can configure the operation of the 507 Compact Disc Player to suit the way your system is set up, and the way in which you want to use it.
These settings are configured automatically to appropriate values when you choose the standard type settings, and you should not normally need to alter them; see Choosing standard
●Switch the power off and then on again, using the power switch on the back panel, to store the settings.
The table below shows the options you can configure:
Option | Initial Value |
settings, page 24.
To configure the compact disc player
●Switch off the compact disc player, using the power switch on the back panel.
●Switch on the power again while holding down Display (front panel).
The display will initially show the
Comms type (500 or 200).
Controller mode (Auto, Con, or NCon).
System address
Product address
Start source.
500
Auto
S.A. 1
P.A. 1
Configuring the
software revision number, then:
It will then show the first
Config
Volume displays (Y or N).
S.S. CD |
Vol N |
compact
configuration option:
500
disc player
●Press Display to move between the options.
● Press [ or ] to change the value of the current option. | 25 |
|