Mesa/Boogie LoneStar Amplifier owner manual FRONT PANEL Controls & Features

FRONT PANEL: Controls & Features

INPUT: This is the instrument INPUT jack. This jack feeds the preamp and since the LONE STAR is a high gain amplifi er and therefore very sensitive, always use a high quality shielded cable between the instrument and the amplifi er.This will prevent unwanted noise and microphonic cable sounds.

INPUT

FT.SW

FOOTSWITCH: This 1/4 inch ” stereo jack is for connection of the Channel Select Footswitch. When the FOOTSWITCH is con- nected here with the provided stereo cable, the Channels and SOLO feature may be controlled remotely.

INPUT

FT.SW

DRIVE: This is the pre-drive control for the high gain preamp in Channel 2. It may be switched out of the circuit, along with its associated tube stages, to create a slightly higher gain clone of Channel 1 in (this bottom) Channel 2. When the DRIVE control is activated (switch left, towards DRIVE), this control operates in conjunction with the GAIN control to meter the amount of preamp drive

that will be introduced into the circuit.

	CH 1
FT	SW
INPUT	CH 2
DRIVE	CLEAN
FT.SW	THICK
NOR	MAL

THICKER

Generally speaking, you will fi nd better response and dynamics combined with smoother saturation by setting the GAIN control higher than DRIVE . In fact you might try leaving the GAIN set to 2:00 or 3:00 and just playing with the DRIVE to learn the regions of saturation.You will probably fi nd the more blues oriented sounds between 9:00 and 11:00, while the really saturated high gain sounds appear between 1:00 and 3:00.

Setting the GAIN control slightly higher than the DRIVE will produce a warmer quality to the sound and in most cases this is preferable. By all means experiment with setting the GAIN lower than the DRIVE , as the brighter, thinner character may be desirable for your application.

Learning the relationship between these two controls is probably the most important element to fi nding your signature lead sound. They are extremely powerful, as they control how your guitar feeds the preamp and also determine the signal strength that is pumped through the tone control string. This in turn affects how the tone controls will respond. At extremely high settings you will be hearing mostly gain saturation as the tone controls become recessive due to over-saturation.

This is fi ne if complete saturation is the desired effect, but remember, many of the best sounds are found with more moderate settings where the gain controls interact with the tone control string to produce a balance of frequencies.

PAGE 4