FRONT PANEL: Controls & Features (Continued)
tone.This scheme would be further enhanced by selecting the TUBE RECTIFIER: TRACKING setting on the Rear Panel RECTIFIER SELECT switch.
Or, you might want the opposite and set Channel 1 to 50 watts of sparkling, yet forgiving clean performance and go for the bold auth- ority of 100 watt power for Channel 2 set to a soaring high gain voice using the DRIVE circuitry.
Whatever scheme you choose to use, the ability to select the power rating of each channel adds incredible expression power to the
LONE STAR
NOTE: The RECTIFIER SWITCH (Rear Panel) has a built in RECTIFIER TRACKING feature that ensures proper matching for each power setting. In 50W, either a TUBE RECTIFIER or a silicon DIODE may be chosen as the rectifi cation element with the Tube offering the most give and elasticity. In the 100W setting, DIODE rectifi ers are automatically brought on line and this is a proper match which provides the reliable and powerful headroom of a 4x6L6 output section.
NOTE: At some point in your experimentation with the Channel Power Select switches, try setting one or both of the Channels to 50W and moving the Speaker Load to the 4 Ohm jack. This produces a brighter, snappier response that is great for certain applica- tions, especially clean sounds. There is no right way, but the difference in response is defi nitely worth investigating for both clean and overdriven sounds.
OUTPUT & SOLO CONTROLS: OUTPUT: This control determines the overall output volume level of the amplifi er. After the
GAIN controls have been set for the desired sound style and the two channels levels have been balanced with the channel MASTER controls, the OUTPUT control allows you to change the playing level by adjusting a single
| 100 W | control. The OUTPUT control is also wired as the Effects Loop Return Level control. |
|
| |
| OUTPUT | LOOP ON SOLO |
| ||
| 50 W | Should you ever use your LONE STAR amplifi er as a power amp alone by inserting a signal |
| into the RETURN jack, the OUTPUT control will serve as the master level control. | |
MASTER | ||
| 100 W |
|
50 W
controls the volume of the power section.
NOTE: To use the LONE STAR amplifi er as a power amp - use the EFFECTS RE- TURN as an input. The SOLO control can be used to attain a footswitchable boost if the Footswitch is connected. It is wired in parallel to the OUTPUT control and therefore also
NOTE: The Effects Loop RETURN jack can serve as a power amp input so that you may use the LONE STAR amplifi er as a power amp for either stereo reproduction or to incorporate additional
1.) Connect “Dummy” plug or loose cable to SEND jack. ( This prevents any possible loading that could result in diminished RETURN sensitivity.)
2.) The OUTPUT Level will be the only active control on the Front Panel (the PRESENCE control of Channel 1 will be active only when that channel is engaged - see #3 )
3.) The SOLO control may be used to footswitch to a
NOTE: Therefore, we recommend selecting Channel 1 when you wish to use the LONE STAR as a power amp.
PAGE 9