Metra Electronics 99-8100 installation instructions Toyota Camry, Toyota Celica / Supra

TOYOTA Camry 1983-86

ALL VEHICLES

1

Disconnect the negative battery terminal to prevent an accidental short circuit. Remove

(3)Phillips screws above the climate controls. Remove (2) Phillips screws from the left side of the dash trim bezel and remove the bezel. Remove the screws securing the factory head unit and disconnect the wiring.

2 "D"

"D"

Slide Mounting Tabs #3 into slots "D" on Bracket Set #2. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.

3

Fig. A

Fig. B

TOYOTA Celica / Supra 1983-85

1

Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the ashtray and the climate control knobs. Remove (3) flat-head screws from the climate control panel and remove the panel. Remove (2) Phillips screws from the top edge of the radio trim bezel. Remove (4) Phillips screws from the base of the radio trim bezel and remove the bezel. Remove

(4)Phillips screws from the factory head unit and disconnect the wiring.

1

2

"A"

"A"

Slide Mounting Tabs #3 into slots "A" on Bracket Set #2. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.

Fig. C

CELICA 1990-93, COROLLA (sport coupe/liftback) 1982-83, COROLLA (sedan/wagon- lower dash) 1988-92, COROLLA 1984-87, LANDCRUISER 1988-92, MR2 1987-90, PICKUP 1984-88, CRESSIDA, 4RUNNER: MountBracket Set #1 to Radio Housing #1 with

(4) Phillips Pan-head Screws supplied. (see Fig. A)

CELICA 1982-85, CELICA 1986-89, COROLLA (lower dash) 1988-92, PICKUP (double DIN) 1989-91, SUPRA 1982-85, CAMRY: Mount Bracket Set #2 to Radio Housing #1 with

(4) Phillips Pan-head Screws supplied. (see Fig. B)

COROLLA (upper dash) 1982-83, COROLLA (sedan/wagon-upper dash) 1988-92, LANDCRUISER 1982-87, MR2 1985-86, PICKUP (single DIN) 1989-91: Mount Bracket Set #12 to Radio Housing #2 with (2) Phillips Pan-head Screws supplied. (see Fig. C)

10