TOYOTA Celica 1990-93
TOYOTA Pickup 1984-88 / 4Runner 1984-88
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Pry up on the gear shifter trim panel and remove the panel. Remove (2) screws exposed on the bottom edge of the radio trim bezel. Unclip the bezel, and disconnect the ashtray and cigarette lighter wiring. Remove the screws securing the factory head unit and disconnect the wiring.
2
"A"
Slide Mounting Tabs #3 into slots "A" on Bracket Set #1. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the ashtray and (3) screws from the ashtray bracket. Remove (1) screw from each side of the dash console and unclip the dash trim bezel. Remove the screws securing the factory head unit and disconnect the wiring.
2 | "J" |
"I" |
|
Slide Mounting Tabs #3 into slots "J" and "I" on Bracket Set #1. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
TOYOTA Pickup (single DIN) 1989-91
TOYOTA Corolla (sport coupe/liftback) 1982-83
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(2)screws from each side of the dash trim bezel and remove the bezel. Remove (4) screws securing the upper radio dummy cover to the bezel and remove.
2 | "B" |
"B" |
|
Slide Mounting Tabs #3 into slots "B" on Bracket Set #1. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(3) screws and (1) bolt securing the driver's |
side speaker panel and remove the panel. |
Remove (1) screw from the left side of the |
housing and unsnap the ignition cover. |
Remove the glove compartment assembly |
by removing (1) 10mm bolt from the bottom |
of the speaker panel and (3) screws from the |
right side of the housing. Remove the |
remaining (3) screws securing the radio trim |
bezel. Remove the screws securing the |
factory head unit and disconnect the wiring. |
2
"D"
Slide Mounting Tabs #3 into slots "D" on Bracket Set #12. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
3
8
