Metra Electronics 99-8100 installation instructions Fig. a

4

Fig. A

Fig. B

2-SHAFT HEAD UNITS: Snap the Faceplate onto the front of the Radio Housing. (For applications using Faceplate #2, cut and remove the bottom portion of the Faceplate). Slide the aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A)

DIN HEAD UNITS: Cut and remove the shaft supports from the Faceplate and Radio Housing. (For applications using Faceplate #2, cut and remove the bottom portion of the Faceplate). Snap the Faceplate onto the front of the Housing. Slide the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B)

(If an equalizer will be included, slide the unit into the back of the Radio Housing and secure. If an equalizer will NOT be included, snap the Equalizer Dummy Plate into the opening).

INST 8100

KIT COMPONENTS
Radio	99-8100
Housing #1
	INSTALLATION
	INSTRUCTIONS
Radio
Housing #2
	APPLICATIONS
	CAR	PAGE
Faceplate	TOYOTA
	4Runner 1984-88	8
	Camry 1983-86	1
	Celica 1982-85	1
	Celica (GT/GTS) 1986-89	2
	Celica (ST) 1986-89	2
	Celica 1990-93	3
Equalizer	Corolla (sport coupe/liftback) 1982-83	3
Dummy Plate	Corolla 1984-87	4
	Corolla (sedan/wagon-lower dash) 1988-93	4

5

A

B

C

D

A)Strip wire ends back ½"

B)Twist ends together

C)Solder

D)Tape

6

Celica 1990-93 application shown

	Corolla (sedan/wagon-upper dash) 1988-93			5
	Cressida 1985-87			5
Mounting Tabs #3	Landcruiser	1982-87		6
	Landcruiser	1988-92		6
	MR2 1985-86			7
Mounting Tabs #8	MR2 1987-90			7
	Pickup 1984-88			8
(4) Phillips Pan-head	Pickup (single DIN)		1989-91	8
Screws	Pickup (double DIN)		1989-91	9
	Supra 1983-85			1
	Supra 1986.5-92			9
TOOLS REQUIRED

Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit).

Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit assembly to the sub-dash with those screws previously removed in step #1. (It may be necessary to trim the ends of the Mounting Tabs to provide proper clearance).

Phillips screwdriver
1-800-221-0932	www.metraonline.com

11 rev. 201202

Cutting tool © COPYRIGHT 2001 METRA ELECTRONICS CORPORATION