TOYOTA Pickup (double DIN) 1989-91
TOYOTA Celica (GT/GTS) 1986-89
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(3)screws and (1) bolt securing the driver's side speaker panel and remove the panel. Remove (1) screw from the left side of the housing and unsnap the ignition cover. Remove the glove compartment assembly by removing (1) 10mm bolt from the bottom of the speaker panel and (3) screws from the right side of the housing. Remove the remaining (3) screws securing the radio trim bezel. Remove the screws securing the factory head unit and disconnect the wiring.
2 | "D" |
| "H" |
Slide Mounting Tabs #3 into slots "H" and "D" on Bracket Set #2. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(2)screws from the lower steering column panel and remove the panel. Remove (2) screws exposed on the dash trim bezel. Open the glove box and remove (2) screws exposed. Remove (2) screws from the ashtray cavity and (2) screws from the bracket. Remove (2) screws from each side of the dash trim bezel and unclip the bezel. Remove the screws securing the factory head unit and disconnect the wiring.
2 | "B" |
| "B" |
Slide Mounting Tabs #3 and #8 into slots "B" on Bracket Set #2. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
TOYOTA Supra 1986-92
TOYOTA Celica (ST) 1986-89
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the ashtray and (2) screws from the ashtray cavity. Remove (1) screw to the right of the steering column and (1) screw to the left of the gear shifter. Remove the screws securing the factory head unit and disconnect the wiring.
2 |
Locate the Mounting tabs on Radio Housing #1. (Brackets are NOT required for this vehicle). Skip to the Installation Instructions for ALL VEHICLES on Page #10.
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(2)screws from the lower steering column panel and remove the panel. Remove (2) screws exposed on the dash trim bezel. Open the glove box and remove (2) screws exposed. Remove (2) screws from the ashtray cavity and (2) screws from the bracket. Remove (2) screws from each side of the dash trim bezel and unclip the bezel. Remove the screws securing the factory head unit and disconnect the wiring.
2 |
"C" |
"C" |
Slide Mounting Tabs #8 into slots "C" on Bracket Set #2. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
9
2
