Metz 42TN92 manual Before Switching OnYour TV, Switching The TV ON/OFF

on the screen for a long time. Please note that this does not affect the performance of your product.”

“DO NOT LEAVE YOUR TV AT STAND-BY OR OPERATING WHEN YOU LEAVE YOUR HOUSE”

Before Switching OnYour TV

Power Connection

IMPORTANT: The TV set is designed to op- erate on 230V AC, 50 Hz.

•After unpacking, allow the TV set to reach the ambient room temperature before you con- nect the set to the mains.

Connections To The Aerial Input Socket

75:

CABLE TV

VHF/UHF

REAR OF THE TV

•Connect the aerial or cable TV plug to the Aerial input socket located at the rear of the TV and connect the cable plug coming out from the TV out socket located on the de- vices (VCR, DVB-Tetc.) to this socket as well.

How To Connect Other Devices

IMPORTANT: Switch off the TV before con- necting any external device.

Sockets for external connections are at the rear side of the TV. For connection of other devices via Scart refer to the manuals of the related devices.

Inserting Batteries In The Remote Control Handset

•Remove the battery cover located on the back of the handset by gently pulling down- wards from the indicated part.

•Insert two AAA/LR03 or equivalent type bat- teries inside. Place the batteries in the right directions.

•Replace the battery cover.

NOTE: Remove the batteries from remote control handset when it is not to be used for a long period.Otherwise it can be damaged due to any leakage of batteries.

Switching The TV ON/OFF

To switch the TV on:

Your TV will switch on in two steps:

1- Connect the power supply cord to the sys- tem. Press On/Off switch “ ” at the bot- tom right side of the TV. Then the TV switches itself to stand-by mode and the led becomes red located on the front of the TV.

2- To switch on the TV from stand-by mode either:

Press a digit button on the remote control so that a programme number is selected,

or,

Press the " " or " " button at the bottom of the TV or press the “-P/CH”or “P/CH+” but- ton on the remote control, so that last mode switched off is selected.

By either ways the TV will switch on and the led becomes green.

- 40 -