Meyer 7200 manual Monthly Lubrication, Model

MONTHLY LUBRICATION

L12 Maintain oil level in the corner gearbox at the centerline of the input shafts. Check regularly for any observable oil leakage. If oil leakage is excessive, replace required input/output shaft oil seals. Use ONLY EP #80-90 wt. gear lube oil or an equivalent in corner box, only Lighter weight gear lube oil may be used in temperatures lower than 20°F. Change oil in the gearboxes after the first season of use and regularly thereafter.

L13 Grease (1) brass bushing supporting the rear shaft of the 3rd auger assembly. This zerk is located on the left rear corner of the tank above the inner cross brace.

L14 Maintain the lube level in the (2) spinner gearboxes at 3/4 full. Check regularly for any observable leakage. If leakage is excessive, replace required input/output shaft seals. Lubricate with Semi-Fluid, EP Lithium Base, Gear Grease.

L15 Clean and repack the wheel hubs with axle grease annually. Grease hub through zerk in hub monthly. Be careful not to over grease and force seal out of back side of hub.

ON CORNER OF FRAME

L16 Oil slides on front idler tightener assembly.

L17 Grease (4) material guide pin sleeves. (2) located on each side of the spreader.

ON CORNER OF FRAME

L18 Grease (2) T-post hold down sleeve zerks lo- cated above the cross channel on the underside of the spreader. A zerk is located on the front and one on the rear of the sleeve.

(SHIELDS REMOVED FOR ILLUSTRATIVE PURPOSES ONLY.)

Model 7200 -21-