CWT Series | MICROBOARDS TECHNOLOGY, LLC |
Installation Requirements
System Setup
•Connect the power cable to the CWT Series tower and plug in to a protected power outlet strip or UPS power supply.
•Turn on power to the tower. The system is now ready to use.
Install your CWT Series duplicator in the following environment:
•On a level and stable surface
•In a well ventilated location
•Temperature and humidity
•Temperature:
•Humidity:
Do not install it in the following places:
Under direct sunlight (If the machine is exposed to sunlight, the light should be blocked by a curtain or blind.)
A dusty location
A place where there is a lot of vibration
Near open flame
A place where the temperature and humidity change drastically
Near a heating device such as a heater or furnace
A location where air from an air conditioner blows directly onto the unit
Near a container filled with water such as a vase
In winter during times of low humidity or in a location where static electricity is
generated, use an
Power supply
Use house current as the power source for the unit.
Do not use an outlet near a motor driven appliance (i.e. air conditioner, copying machine).
Use an outlet with stable power supply voltages.
Do not overload an outlet. Do not use a service outlet from a PCs or other office machine.
Wire the power cord properly.
Do not touch the power cord with a wet hand.
Be careful not to damage the power cord.
Inspect the power cord periodically.
In the event that the power cord is damaged, replace the power cord.
Be sure to use a tool such as the screwdriver to change the 115/230V Switch. Do not use your finger.
6
