MicroNet Technology SP3508A 5.11 Port Sniffer

Parameter Description

Port Priority Users can make it more or less likely to become the root port. The

lowest number ha s the highest priority. If users change the value, it

is necessary to reboot the SP3508A.

Range: 0~255.

Default: 128.

Path Cost Specifies the path cost of the port that the SP3508A uses to

determine which port are th e forwarding ports. The lowe st number is

forwarding ports. If users change the value, it is neces sary to reboot

the SP3508A.

Range: 1~65535

Default: 10Mb/s = 50-600

100Mb/s = 10-60

1000Mb/s = 3-10

5.11 Port Sniffer

The Port Sniffer is a method for monitor traffic in SP3508A networks. Traffic

through ports can be monitored by one specific port. Meaning, traffic goes in

or out of monitored ports will be duplicated into sniffer port.

Contents

Main Users Manual 8-Port VDSL Managed Switch Model No.: SP3508A Table of Contents Page Chapter 1 Introduction 1.1 Package Contents 1.2 Key Features Page Chapter 2 Installation 2.1 Hardware Installation 2.2 Pre-installation Requirements 2.3 Cabling Requirements 2.4 Connecting to Gigabit Ethernet 2.5 Connecting to RJ-11 Chapter 3 Physical Description 3.1 LED Definition 3.2 Switch Connectors Chapter 4 IP Address Configuration 4.1 Out-Band Access 4.1.1 Console Port Page Page 4.2 Remote Access 4.2.1 Telnet 4.2.2 Web-Based UI Page Page 5.3 Port Statistics 5.4 IP Address 5.5 Switch Setting 5.5.1 Basic Hardware Version Default config value version 5.5.2 Advanced The interface allow advance configuration of the VDSL Switch. Priority Queue Service Settings Protocol Enable Setting Auto Speed SNR margin value setup 5.6 Port Controls 5.7 Link Aggregation 5.7.1 Aggregator Setting 5.7.2 Aggregator Information 5.7.3 State Activity 5.8 Filter Database 5.8.1 IGMP Snooping 5.8.2 Static MAC Address 5.8.3 Port Security 5.8.4 MAC Filtering 5.9 VLAN Configuration 5.9.1 Basic 5.9.2 Port VID 5.10 Spanning Tree 4. The following parameter can be configured on each port and click <Apply> button to modify. Parameter Description Port Priority Path Cost 5.11 Port Sniffer 5.12 SNMP Page 5.13 Signal to Noise Ratio 5.14 Security Manager 5.15 TFTP Update Firmware 5.16 Configuration Backup 5.16.1 TFTP Restore Configuration 5.16.2 TFTP Backup Configuration 5.17 Reset and Rebooting System Chapter 6 Application Chapter 7 Appendix 7.1 Appendix A: Specifications Humidity 10% ~ 90% non-condensing Page 7.2 Appendix B: Troubleshooting 7.3 Appendix C: System Diagnostics 7.3.1 Power and Cooling Problems 7.3.2 Installation 7.3.3 Transmission Mode 7.3.4 Cabling 7.3.5 Physical Configuration 7.3.6 System Integrity 7.4 Appendix D: VDSL Spectrum VDSL Technology Requirements & Definitions 7.5 Appendix E: Example of VLAN Setting 7.5.1 Port-Based VLAN Setting 7.5.2 Tag-Based (IEEE 802.1Q) VLAN Setting