Connecting I/O Devices, WOL1 Wake On LAN | Microsoft mainboard

connect the front-mounted ports to the mainboard.

Pin	Signal Name	Pin	Signal Name

1	VERG_FP_USBPWR0	2	VERG_FP_USBPWR0
3	USB_FP_P0-	4	USB_FP_P1-
5	USB_FP_P0+	6	USB_FP_P1+
7	GROUND	8	GROUND
9	KEY	10	USB_FP_OC0

WOL1: Wake On LAN

If you have installed a LAN card, use the cable provided with the card to plug into the mainboard WOL1 connector. This enables the Wake On LAN (WOL1) feature. When your system is in a power-saving mode, any LAN signal auto- matically resumes the system. You must enable this item using the Power Management page of the Setup Utility.

Pin	Signal Name

15VSB

2Ground

3SENSE

IR1: Infrared port

The mainboard supports a Infrared (IR1) data port. Infrared ports allow the wireless exchange of information between your computer and similarly equipped devices such as printers, laptops, Personal Digital Assistants (PDAs), and other computers.

Pin	Signal Name	Pin	Signal Name

1	NC	4	Ground
2	Key	5	IRTX
3	+5V	6	IRRX

Connecting I/O Devices

The backplane of the mainboard has the following I/O ports:

18

Image 22

Microsoft mainboard, K7S5A manual Connecting I/O Devices, WOL1 Wake On LAN, IR1 Infrared port

Contents

Preface Copyright Declaration of Conformity Table of Contents Using the Mainboard Software Introducing the Mainboard Introduction ChecklistStandard Items Features Scheme Choosing a Computer Case ROM Mainboard Components Installing the Mainboard Safety Precautions Quick Guide Checking Jumper Settings Installing the Mainboard in a CaseSetting Jumpers Checking Jumper Settings Jumper Settings SPK1 Speaker Connector Connecting Case ComponentsJP2 Onboard LAN LED Connections FPI Connector Before installing the Processor Installing HardwareInstalling the Processor CPU Installation Procedure Installing Memory Modules Follow these instructions to install the CPU Installation Procedure DDR Sdram Module About IDE Devices Installing a Hard Disk Drive/CD-ROMInstalling a Hard Disk Drive About UltraDMA Installing a Floppy Diskette Drive Installing a CD-ROM/DVD Drive Installing Add-on Cards Follow these instructions to install an add-on card Connecting Optional Devices FPAUD1O Front panel MIC/Speaker Out header USB1 Extended USB header WOL1 Wake On LAN Connecting I/O DevicesIR1 Infrared port External Connector Color Coding LPT1 This concludes . The next chapter covers the Bios Using Bios About the Setup Utility Standard Configuration Bios Navigation Keys Running the Setup UtilityUsing Bios Amibios Simple Setup Utility Version Pri Master/Pri Slave/Sec Master/Sec Slave Standard Cmos FeaturesDate & Time Floppy Drive A/Floppy Drive B Advanced Setup System Bios Cacheable Password CheckBoot to OS/2 64MB Timing Setting Mode Power Management Setup PCI / Plug and Play Setup Load Best Performance Settings Load Optimal SettingsFeatures Setup Parallel Port IRQ Parallel Port ModeOnboard Parallel Port Parallel Port DMA CPU Speed CPU PnP SetupCPU Brand/Type/ Core Voltage/Ratio /Frequency Dram Frequency Hardware Monitor System / CPU TemperatureVoltage Measurements & FAN Speeds Change or Remove the Password Change PasswordExit Using the Mainboard Software About the Software CD-ROM Auto-installing under Windows Application Tab Setup TabRead Me Tab Running Setup Manual Installation WinFlash Utility Utility Software ReferenceAMI Flash Memory Utility MediaRing Talk Telephony Software Language Genius Recovery GeniusCD Ghost PageABC