![](/images/new-backgrounds/1092294/9229433x1.webp)
If the oven uses this Digital Temperature Controller:
5b. Adjust the temperature |
controller to a desired set |
temperature, if neces- |
B.DAILYSHUTDOWNPROCEDURE
1.Turn the "BLOWER" () and "CONVEYOR" (
)
switches to the "OFF" ("O") position. Open the window (if so equipped) to allow the oven to cool faster.
Note that the blowers will remain in operation until the oven has cooled to below 200°F (93°C).
+
![](/images/new-backgrounds/1092294/9229433xi4.webp)
![](/images/new-backgrounds/1092294/9229433xi5.webp)
![](/images/new-backgrounds/1092294/9229433xi6.webp)
ENGLISH
sary. | + | |
• Press the Set Point | ||
| ||
and Unlock keys at |
| |
the same time. Wait | wait | |
for the "SET PT" light | ||
to turn on. | for | |
• Press the Up Arrow |
| |
and Down Arrow |
| |
Keys as necessary | or | |
to adjust the set- | ||
point. |
|
6b. Check that the "HEAT ON" |
| |
light illuminates. | This | wait |
shows that the burner or | ||
heating elements | have | for |
been turned on. |
|
|
7b. Wait for the oven to heat to the setpoint temperature. Higher setpoint temperatures will require a longer wait. The oven can reach a temperature of 500°F (232°C) in approximately 5 minutes.
8b. (Optional) Press the Tem- perature () key to show
the Actual Temperature |
|
in the display, and wait |
|
for the "ACTUAL TEMP" |
|
light to turn on. This al- |
|
lows you to monitor the |
|
oven temperature as it | wait |
rises to the setpoint. | for |
9b. Allow the oven to preheat for 10 minutes after it has reached the set point temperature.
3.After the oven has cooled and the blowers are off, switch the circuit breaker/fused disconnect to the off position.
IMPORTANT
On gas ovens, if the "HEAT ON" light will not illuminate, OR if the oven does not heat, the gas burner may not have lit. Turn the "BLOWER" () and "CONVEYOR" (
) switches to the "OFF" ("O") position. Wait for AT LEAST FIVE MIN- UTES before restarting the oven. Then, repeat the Daily Startup procedure.
CAUTION
In case of power failure, turn all switches to the “OFF” ("O") position, open the oven window (if so equipped), and remove the product. After the power has been restored, perform the normal startup procedure. IF THE OVEN WAS SWITCHED OFF FOR LESS THAN 5 MINUTES, WAIT FOR AT LEAST FIVE MINUTES BEFORE RESTARTING THE OVEN.
No attempt should be made to operate the oven during a power failure. In gas ovens, the burner will not operate and gas will not flow through the burner without electric power.
17