70-440 User manual

Monitor Button

The Monitor button can enable or disable “GROUP MODE (CTCSS/DCS)” if programmed for that channel.

1)To enable GROUP MODE. Press and release the“MON” button: “SAT” icon is displayed. A Sub Audible Tone mutes your speaker.

2)To Disable GROUP MODE. Press the “MON” button: “SAT” icon is not displayed. You are now working in “Open Traffic”.

NOTE: if “SAT” icon is never displayed, “CTCSS/DCS” tone is not programmed. “GROUP MODE” function is not available.

3)Press and Hold “MON” button for three seconds, internal squelch will be disabled and your speaker is un-muted. Press and release the “MON” button to restore the squelch to normal operating condition.

Transmitting

1)Ensure that the channel is not busy otherwise you will create interference.

2)Press the “PTT” button, the status LED will glow red.

3)Start talking at a normal voice level at approximately 2.5 inches from the microphone (keep the “PTT” button pressed).

4)When you have finished talking, release the “PTT” button.

Do not shout! It will not increase the distance you can transmit, but rather will make you heard distorted.

Do not release the “PTT” button before your message is over or start talking before pressing “PTT”, otherwise your message will be “chopped”.

A handheld radio does not allow you to talk and receive simultaneously, for this reason make your messages short. When you are talking the other parties can not use the channel! Use common sense.

Your radio is programmed with a timeout timer which will automatically turn off the transmitter if you talk longer than 90 seconds. In this case release the “PTT” and wait for few seconds, the radio TX features will be automatically restored.

Adjusting Transmit Power

Your 70-440BP can transmit with two power levels according to the distance of your party’s station(s). We do recommend, when possible, to use the Low power setting. This will increase the battery life and will reduce the risk of interference with other stations not in your radio network that may be sharing the same channel with you.

1)To change the channel's Power Output level from high (2 Watts) to Low (0.5 Watt), or vice versa, Press and Hold “FUNC” key for about 2 seconds. A small "LOW" will appear in the lower left corner of the display to indicate “Low Power”. High Power has no indicator.

Page. 13

Page 13
Image 13
Midland Radio 70-440BP user manual Monitor Button, Transmitting, Adjusting Transmit Power