Cleaning and care
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety Instructions".
The halogen bulbs are very hot when in use. They stay hot for some time after turned off. Use caution, danger of burns.
Wet cleaning the hot bulbs will cause damage.
Wait a few minutes after turning them off before cleaning.
Cleaning the casing
Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. They will damage the surface.
All external surfaces and controls can be cleaned with a mild solution of warm water and liquid dish soap applied with a soft sponge.
Wipe dry using a soft cloth.
Do not use too much water when cleaning the controls. Water could penetrate the electronics and cause damage.
Avoid:
–cleaning agents containing soda, acids or chlorides,
–abrasive cleaning agents
e.g. powder or cream cleansers,
–abrasive sponges, e.g. pot scourers or sponges which have been previously used with abrasive cleaning agents.
These will damage the surface.
The following instructions for cleaning "Stainless steel" surfaces and "Stainless steel colored controls" should be followed in addition to the general "Cleaning the casing" instructions.
Stainless steel surfaces
Stainless steel surfaces can be cleaned using a
To help prevent resoiling, a conditioner for stainless steel can be applied.
Stainless steel colored controls
These controls may become dis- colored or damaged if not cleaned regularly.
Do not use a stainless steel cleaner on these controls.
12
