Maintenance 
Cleaning
WARNING!!
Always disconnect the power supply be- fore cleaning or servicing the oven.
WARNING!!
If the oven needs to be moved, the gas must be turned off and disconnected from the unit before removing the restraint. Re- connect the restraint after the oven has been returned to its original location.
Follow this recommended cleaning schedule for proper oven performance.
Daily:
1.Clean the conveyor belt using a wire brush. Al- low any foreign material to drop into the crumb pans.
2.Remove the product stop and both crumb pans from the ends of the conveyor.
3.Empty and clean the crumb pans with a hot water/detergent mix. Rinse with clean water.
Every Three Months:
1.Unplug the 220V power cord.
2.Disconnect the gas. Be sure that the oven control cables have
3.Clean the cooling fan louvers on both sides of the oven with a soft brush.
Every Six Months:
1.Remove the product stop and both crumb pans from the ends of the conveyor.
2.Remove both upper end plugs. Loosen the wing nuts on the bottom of each end plug.
Figure 17
3.Remove the air plates as follows:
a.) Loosen the wing screws holding the air plate retainers in place. Remove the four wing screws from the control box end of the oven.
Figure 18
b.) Slide the air plates straight out from both ends of the oven.
Figure 19
19
