Venting, Electrical connection, Air extraction mode

		Installation
	7. Venting
	Air extraction mode
	Complete the venting installation, see
	"Air extraction".
	Recirculation mode
	If the hood cannot be installed for air
	extraction the appliance must be
	connected for recirculation mode.
	For recirculation mode a respective
	installation kit is recommended which
	can be obtained from Miele.
	In addition an active charcoal filter is
	needed.
		Install the installation kit as described
		in the manual supplied with the kit.
	The non-return flap is not needed for	Make sure that the slats in the grill
	the recirculation mode. Pull the	point towards the center of the room
	non-return flap off the bracket from	point towards the center of the room
	non-return flap off the bracket from	and not towards a wall or the ceiling.
	the vent connection.	and not towards a wall or the ceiling.
	the vent connection.
		Install the Active Charcoal Filter (see
		"Cleaning and care").

8. Electrical connection

Refer to the notes in "Electrical connection" and "Important Safety Instructions" before connecting to the mains.

Plug in the power cord.