Cleaning and care
Cleaning the grease filter by hand
Clean the filter with a soft nylon brush in a mild solution of hot water and a small amount of
Do not use:
–cleaning agents containing descaling agents,
–powder cleaners, cream cleaners or abrasive
–oven sprays.
Cleaning the grease filter in the dishwasher
Place the filter as upright as possible in the lower basket, with the short sides upright. Make sure that the spray arm can move freely.
Do not wash at more than 65° C. If a Miele dishwasher is being used, select the Sensor wash programme.
Use a mild dishwasher detergent.
Depending on the cleaning agent used, cleaning the filter in a dishwasher can cause permanent discolouration to the surface. However, this will not affect the functioning of the filter in any way.
After cleaning, leave the filter to dry for a while on an absorbent surface before putting it back in place.
When removing the filter for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire.
When putting the grease filter back in position, ensure that the locking clip is visible facing down towards the hob.
If the grease filter is inadvertently replaced upside down, insert a small screwdriver blade into the slit to disengage the clip.
After replacing the grease filter, press the operating hours control for approximately 3 seconds to reset the operating hours counter.
The indicator lamp will go out.
If the grease filter is cleaned before the operating hours counter has reached its maximum, the operating hours control should be pressed for approximately 6 seconds to reset the counter.
24
