Miele DA 6480, DA 6490, DAG 500, DAG 1000 Electrical connection, This Appliance Must Be Grounded

Electrical connection

￿WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

All electrical work should be performed by a qualified electrician in strict accordance with national regulations and local safety regulations.

Installation, repairs and other work by unqualified persons could be dangerous.

Ensure that power to the appliance is off while installation or repair work is performed.

The ventilation system may only be used with Miele DAG 500 or DAG 1000 blowers.

￿Verify that the voltage, load and circuit rating information found on the data plate, match the household electrical supply before installing the ventilation system.

If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or contact Miele’s Technical Service Department. See back cover for contact information.

WARNING:

THIS APPLIANCE MUST BE GROUNDED

￿If you have not yet done so, remove the cover of the terminal box.

￿Install a suitable UL listed cable clamp or conduit fitting at the cable knock-out.

￿Pass the power supply cable through the knock-out of the housing into the terminal box.

Important

The ventilation system must be hard wired as follows:

Black wire:	. . . . . . . connect to L1 (live)
White wire:	. . . . . connect to N (neutral)

Green-yellow wire: . . . connect to GND

. . . . . . . . . . . . . . . . . . . . . . . . . (ground)

37