Installing the appliance
Securing an alternative anti-tip device
If the
Ensure that there is no "give" between the appliance and the
If possible, always screw the wooden beam to existing studs.
Cut a wooden beam (cross section min. 3" x 4"
[75 mm x 100 mm]) to the required length.
The length is equal to the width of the installation niche.
–If the installation niche is deeper than the appliance, select a beam with a larger cross section, or attach two beams.
–The beam must cover the appliance by at least 2" (50.8 mm).
Mark the installation height (lower edge of the beam) on the rear wall of the niche.
Select screws according to the thickness of the wooden beam. Example: 3 ½" screw for 2x4 beam.
Determine the number of screws based on the cavity width, to ensure that the beam will be attached securely.
Locate wall studs near the rear wall of the cavity and mark drill holes in the beam.
Attach the wooden beam to the rear wall of the niche.
If a
Now prepare the water connection from the appliance to the main supply line (see "Plumbing").
61
