Settings ￿

Optimize standby

A few minutes after the last key is pressed or at the end of the program the dishwasher will switch into Standby mode to save energy.

This function can also be turned off. The dishwasher will then turn off completely after 6 hours.

￿Select the desired setting and confirm with OK.

If the Standby option is turned on, the clock will only be displayed for a few minutes.

If refill salt and/or rinse aid or an fault are present in the display, the dishwasher will not turn off.

The refill messages can be turned off when you use a tab detergent (see "Settings-Refill display"). Fault messages cannot be turned off.

Refill display

When consistently using multi-function Tab detergents, you can turn off the refill displays.

￿Select the desired setting and confirm with OK.

Be sure to turn this setting back on if you stop using multi-function tab detergents.

Check filters

This selection allows you to set the number of programs run before the filter check message shows.

You can select between 30 and 60 programs.

The filter check message is set by default to 50 programs.

￿Select the desired number of programs and confirm with OK.

51

Page 51
Image 51
Miele G 5910, G 5915 operating instructions Optimize standby, Refill display, Check filters