Miele H 4681 Light, Main menu, Catalyser, Cooling fan run-on, Changing settings

Changing settings

Light

The oven interior lighting can be set so that it goes out 15 seconds after a cooking programme has started, or so that it stays on throughout cooking.

If this option has been set, the lighting can be switched back on for a further 15 seconds by pressing one of the sensors next to the display.

Main menu

The first four options in the main menu can be allocated to functions or user programmes which you use more frequently than the pre-set functions.

Each option is shown as a position and can be changed. You can select other options from the range of functions and also your user programmes.

You can change to the position required by confirming "Continue" even if no changes have been made.

Catalyser

The oven is supplied with the catalyser engaged for all functions except Gentle bake.

If the catalyser is set to:

–"On" it will also work during Gentle bake.

–"Off next programme only" it will be switched off during the next programme but only if a temperature of over 150 °C is reached. If this temperature is not reached, the setting will apply to the following programme too.

–"Factory default" the settings the oven was supplied with will be re-instated.

Cooling fan run-on

The cooling fan will continue to run for a while after the oven has been switched off to prevent any humidity building up in the oven, on the control panel or in the oven housing unit.

The cooling fan is sensor controlled and will switch off automatically.

You can change the factory default setting and set the cooling fan to switch off when the temperature in the oven is below about 70 °C or to switch off after a period of about 25 minutes.

Do not leave food in the oven to keep it warm if you have set the cooling fan to timed operation.

Moisture levels in the oven could increase, leading to condensation forming on the control panel and surrounding kitchen furniture and drops of moisture collecting under the worktop.

Condensate can

–damage the housing unit / worktop.

–lead to corrosion in the oven.

30