Building in the appliance
^Then align the appliance front to the front edges of the side walls of the housing unit.
^Secure plastic bracket d to the side opposite the hinges using the M5 x 22 screws e.
^Push the appliance in until the plastic bracket is flush with the front edge of the housing unit floor f.
Securing the appliance
^To fix the appliance to the housing unit at the top and bottom:
–screw the long 4 x 19 mm chip board screws a into all of the hinge plates,
–open the plastic bracket, and screw a long chipboard screw b (4 x 19 mm) through the middle of the long hole in the plastic bracket.
^Close the plastic bracket.
^Close the appliance doors.
Fitting the furniture doors
^A gap of 8 mm a must be set between the appliance door and the fixing bracket.
^Push fitting aids d up to the height of the furniture door: the lower edge "X" of the fitting aids must be at the same
height as the upper edge of the furniture door being fitted (see - on the diagram).
^Undo nuts b, and take fixing bracket c off together with the fitting aids.
56
