Installation
Cutting out the countertop
All Miele combisets have the same length and width. Make sure that there is enough room beneath the countertop to allow for the depth of the various appliances. When installing a KM 402 / KM 403 or KM 410 / KM 411 remember to allow clearance for the drain valve that will be located in the cabinet beneath the appliances.
The following safety distances must be maintained:
–Between the cooktop and rear wall: 2" (50 mm).
–Between the cooktop and side wall or cabinet:
KM 400 = 2" (50 mm)
KM 402 / 403= 2" (50 mm) KM
KM 410 / 411 =10" (250 mm)
Refer to section "Important Safety Instructions" for further information.
Installing one or multiple appliances:
Cut out the countertop using the dimensions listed in the following table.
Number of | Cut out width | |
cooktops | Dimension "B" | |
1 | 10 13/16" | (274 mm) |
2 | 22 1/8" | (562 mm) |
3 | 33 7/16" | (850 mm) |
4 | 44 13/16 | (1138 mm) |
5 | 56 1/8" | (1426 mm) |
6 | 67 1/2" | (1714 mm) |
7 | 78 13/16" | (2002 mm) |
The tolerance for each dimension is 1/16" (1 mm).
When installing more than one combiset cooktop, a support bar must be installed between the appliances. Install the support bars as shown on the following page before setting the appliances into the countertop.
9
