Gas connection
Gas pressure regulator
A pressure regulator that is convertible from natural to LP gas (Propane) or vice versa is included with the appliance.
The included regulator corresponds with the gas type of the cooktop. Verify before installing.
The adjusted pressure is: natural gas - 4" w.c.
LP gas - 10" w.c.
aCooktop
b½" NPT
cRegulator
As shown in the above diagram, the included regulator must be used when connecting the Miele cooktop to your gas supply. This item has been customized by Miele to meet all applicable safety requirements. Make sure the regulator is easily accessible for adjustment after the appliance has been installed.
For convenience, an AGA or CGA approved flexible stainless steel gas hose (accordion type) may be used between the gas connection and the regulator. This will allow the appliance to be lifted out of the countertop for cleaning or servicing. Make sure that any drawers, cabinet doors, etc., do not rub on this gas hose.
Do not use any regulator unless it has been supplied by Miele. Doing so may cause a gas leak.
If there is any doubt concerning installation contact the Miele Technical Service Department:
U
V
After connecting the appliance check all fittings for gas leaks e.g. with soapy water.
When installed properly, the flame will be steady and quiet. It will also have a sharp, blue inner core that will vary in length proportional to the burner size.
Flame adjustment will not be necessary.
33
