INSTALLATION INSTRUCTIONS Installation
Installation surface
Experience has shown that a concrete floor is the most suitable surface for a washing machine. Concrete floors are far less prone to vibration during the spin cycle than wooden floors.
Please note the following points:
The machine must be level and se- curely positioned.
To avoid vibrations during spinning, the machine should not be installed on soft floor coverings.
If installation must be on a wooden joist floor, we recommend the use of a plywood base at least 11/4" thick and 23 5/8" X 23 5/8" wide (30mm X 600mm X 600mm). Ideally the base should be large enough to span sev- eral joists and should be anchored to the joists and not just the floor- boards.
As a general rule, we recommend the installation of the machine (or washer/dryer stack) in the corner of a room where the stability of the floor is at its greatest.
If the machine is installed on a raised platform, it should be secured using retaining clips (available from the Miele Parts Dept.). If installed on a masonary or concrete base, the base should be provided with a rim 1/2" to 3/4"
Installation
Lift the machine from its shipping pallet and move it to the installation site. Please note:
Do not lift the machine by the drum door.
Ensure that the machine feet and the floor are dry to prevent slippage dur- ing the spin cycle.
Removing the shipping struts
Using adjustable pliers, pull out the retaining clips on the right and left of the support plate.
Turn the
32
