INSTALLATION (continued)
Install Cable
COPPER
OPERATION
After installation, the media converter should function without operator intervention.
T1 100 OHM (RJ-45 CONNECTOR)
OR E1 120 OHM
NOTE: KEEP
•Locate or build
•Connect male
•Set
•Connect male
E1 75 OHM (COAX CONNECTOR)
Status LEDs
Use the status LEDs to monitor media converter operation in the network.
Power | Steady green |
| LED indicates |
| connection to |
| external AC |
| power. |
SDFiber | Signal |
| Detect/Fiber - |
| Steady green |
| LED indicates |
| fiber link is up. |
Power
SDFiber
AISFiber
Coax
SDTP AISTP
NOTE: Ground coax segment to earth ground at one end.
•Locate or build coax cables that are compliant with specifications on page 10.
•Connect BNC connector at one end of cable to media converter.
•Connect BNC connector at other end of cable to network equipment..
FIBER
•Locate or build duplex fiber cables that are compliant with specifications on page 10.
•Connect male TX and RX cable connectors at one end of cable to TX and RX female connectors, respectively, on media converter.
•Connect male TX and RX cable connectors at other end of cable to RX and TX connectors of compliant fiber device.
Connect to Power
•Install Power Adapter cord at back of Media Converter.
•Connect Power Adapter plug to AC power.
•Verify that Media Converter is powered by observing illuminated LED(s).
AISFiber | All Ones Insertion/Fiber - Blinking green LED indicates all ones |
| received on fiber |
Coax | Steady green LED indicates coax interface selected. |
SDTP | Signal |
| |
AISTP | All Ones |
| all ones received on |