Miller Electric 125C, ICE-12C manual Torch And Work Cable Connections, Torch Connections

6-3. Torch And Work Cable Connections

If torch or work cable needs to be removed or replaced, proceed as follows:

4

4	5
	8	6

7

1

5 6 2

2

3

3

4 5 8 6

Tools Needed:

5/8 in

Turn power Off, and disconnect input power plug from receptacle. Remove wrapper from unit.

Torch Connections

Remove existing torch cable from unit.

1Strain Relief

2Torch Cable

Insert cable through strain relief. Slide strain relief nut onto torch cable, but do not tighten.

3 Air Line Connector

Install air line connector into compressor fitting.

4 Plug PLG4/Receptacle RC4

Connect PLG4 to receptacle RC4 on circuit board PC1.

5Female And Male Friction Terminal RC11/ELECT

WHITE

Connect female friction terminal on end of white leads to RC11/ELECT

WHITE.

6Female And Male Friction Terminal RC7/PILOT RED

Connect female friction terminal on end red leads to RC7/PILOT RED.

Tighten strain relief nut.

Tighten strain relief around cable.

Work Cable Connections

Remove existing work cable from unit.

7 Strain Relief

.Be sure to allow some work cable slack inside the unit.

Insert work clamp lead through strain relief, and install strain relief into front panel.

8Work Lead Male Friction Terminal

Connect work clamp lead to male friction terminal labeled WORK LEAD on circuit board PC1. Route lead along torch lead bundle.

Ref. 803 639-B / Ref. 801 300-B / 204 308-A

OM-2248 Page 18