4-6. Connecting Work Clamp

1

2

1Work Clamp

2Workpiece

Connect work clamp to a clean, paint-free location on workpiece, as close to cutting area as possible.

802 463-A

4-7. Connecting Input Power

1

23

4

Check input voltage available at site.

1Grounded 120 VAC Receptacle (Non-CE Models)

A 120 volt, 20 ampere individual branch circuit protected by time-delay fuses or circuit breaker is required (see Section 4-1).

2 Plug From Unit

Select extension cord of 12 AWG for up to 53 ft (16 m).

3Grounded 230 VAC Receptacle (CE Models)

A 230 volt, 10 ampere individual branch circuit protected by time-delay fuses or circuit breaker is required (see Section 4-1).

4Plug From Unit (Customer Supplied)

Select extension cord of 14 AWG for up to 133 ft (41 m).

YSpecial installation may be required where gasoline or volatile liquids are present − see NEC Article 511 or CEC Section 20.

802 460-B

OM-2248 Page 12

Page 16
Image 16
Miller Electric 125C, ICE-12C manual Connecting Work Clamp, Connecting Input Power